Saturday, February 18, 2012

protected MallinCam

While the gang went tobogganing, I kept the fires burning. And continued to cut the foam for "new" MallinCam case.

I had brought up two foam slabs at New Years. I used one of the 2" thick slabs in the bottom of the toolbox. Made voids or slots for the camera, transformer, AVerMedia PCMCIA card, RS-485 adapter, and the BNC cable. Dietmar reminded me to make the voids deep enough so the tray would fit on top. Thank you.

Works good. Forgot to take a pix.

No comments: